我一开始也越到一抹一样的问题，用的是OCZ的1333cl5条子，后来换上Gskill/1600cl7就没有重起过。我觉得大家玩超频那么长时间设置不会有太大问题，要不然就是内存兼容性问题。这只有靠以后的bios慢慢改进了！
我给你个最简单的设置方法，U是X3350，这两天一直在测试，没出现任何问题。
JumperFree Configuration Settings
AI Overclock tuner: Manual
CPU Ratio Setting: Auto
FSB Strap to North Bridge: auto
FSB Frequency: 400
PCI-E Frequency: 100
DRAM Frequency: 1600
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: Manual
1st Information :
CAS# Latency: 7
DRAM RAS# to CAS# Delay: 7
DRAM RAS# Precharge: 7
DRAM RAS# Activate to Precharge: 18
RAS# to RAS# Delay : A
Row Refresh Cycle Time: A
Write Recovery Time:A
Read to Precharge Time: A
2nd Information :
READ to WRITE Delay (S/D): A
Write to Read Delay (S): A
WRITE to READ Delay (D): A
READ to READ Delay (S): A
READ to READ Delay (D): A
WRITE to WRITE Delay (S): A
WRITE to WRITE Delay (D): A
3rd Information :
WRITE to PRE Delay: A
READ to PRE Delay: A
PRE to PRE Delay: A
ALL PRE to ACT Delay: A
ALL PRE to REF Delay: A
DRAM Static Read Control: D
DRAM Read Training: D
MEM. OC Charger: Enable
AI Clock Twister: A
AI Transaction Booster: A
Common Performance Level :
Pull-In of CHA PH1: DISABLED
Pull-In of CHA PH2: DISABLED
Pull-In of CHA PH3: DISABLED
Pull-In of CHA PH4: DISABLED
Pull-In of CHB PH1: DISABLED
Pull-In of CHB PH2: DISABLED
Pull-In of CHB PH3: DISABLED
Pull-In of CHB PH4: DISABLED
CPU Voltage: 1.25
CPU GTL Voltage Reference (0/2): AUTO
CPU GTL Voltage Reference (1/3): AUTO
CPU PLL Voltage: A
FSB Termination Voltage: A
DRAM Voltage: 1.90V
NB Voltage: A
NB GTL Reference: AUTO
SBridge Voltage: A
PCIE SATA Voltage: A
Load Line Calibration: enable
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : A
NB Clock Skew : A
Advance CPU Settings
CPU Ratio Setting: Manual
CPU VID: Default
C1E Suppport: Disabled
Max CPUID Value Limit: Disabled
Intel? Virtualization Tech: E
Vanderpool Technology: E
CPU TM Function: E
这都是自己摸索的，不是100%适用，你自己再琢磨一下吧，愿成功解决！
