JumperFree Configuration Settings
AI Overclock tuner: Manual
CPU Ratio Setting: 6－9倍频调节
FSB Strap to North Bridge: 内存除频选项一般先1：1跑就是选｛333\667｝看U可以上极限多少在除频跑吧！
FSB Frequency: CPU频率多少自己设置
PCI-E Frequency: 100
DRAM Frequency: 内存频率
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: Manual
1st Information :
CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : A
Row Refresh Cycle Time: A
Write Recovery Time:A
Read to Precharge Time: A
2nd Information :
READ to WRITE Delay (S/D): A
Write to Read Delay (S): A
WRITE to READ Delay (D): A
READ to READ Delay (S): A
READ to READ Delay (D): A
WRITE to WRITE Delay (S): A
WRITE to WRITE Delay (D): A
3rd Information :
WRITE to PRE Delay: A
READ to PRE Delay: A
PRE to PRE Delay: A
ALL PRE to ACT Delay: A
ALL PRE to REF Delay: A
DRAM Static Read Control: Disabled 关闭。。要效能就打开
DRAM Read Training:Disabled 关闭。。。要效能就打开
MEM. OC Charger: E超高频选择打开。（我自己不论跑多少都是打开）
AI Clock Twister: A
AI Transaction Booster: Manual, or auto
Common Performance Level :
Pull-In of CHA PH1: DISABLED
Pull-In of CHA PH2: DISABLED
Pull-In of CHA PH3: DISABLED
Pull-In of CHA PH4: DISABLED
Pull-In of CHB PH1: DISABLED
Pull-In of CHB PH2: DISABLED
Pull-In of CHB PH3: DISABLED
Pull-In of CHB PH4: DISABLED
CPU Voltage: CPU电压自己设置
CPU GTL Voltage Reference (0/2): AUTO
CPU GTL Voltage Reference (1/3): AUTO
CPU PLL Voltage:1.5－1.54V不要太高了(1.5V平时可以用了。自己1.5V跑480X8了）
FSB Termination Voltage: 1.20V~1.24 （1.2V平时可以用了，可以跑480X8）
DRAM Voltage: 内存电压自己设置
NB Voltage: 1.1－1.48不要太高了，自己跑Q6600可以跑480X8了，一般1.1V电压也可以跑480X8，自己设置过默认1.1V可以跑445X9 4G了
NB GTL Reference: AUTO
SBridge Voltage: AUTO
PCIE SATA Voltage: AUTO
Load Line Calibration: 防CPU掉压的（这个选择开）
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : 100~300ps 可以相对调整（注：65NM的设置100PS 45NM的300PS）
NB Clock Skew : 100ps
Advance CPU Settings
CPU Ratio Setting: Manual
CPU VID: Default
C1E Suppport: Disabled
Max CPUID Value Limit: Disabled
Intel? Virtualization Tech: Disabled
Vanderpool Technology: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Disabled
以上借用狂少的设置，有部分是自己改的大家参考下！有意见的话大家提出来讨论。3Q
自己用以上设置可以跑480X8 内存跑1200 4X1G CPUQ6600
[
本帖最后由 yfxx 于 2008-6-23 16:56 编辑 ]
